CO2 splitter

Just installed a 3 way splitter. Years of fabricating splitters out of this, that's and bubble gum I finally  broke down and purchased one. Had to remove the old needle valve. Sure glad I had enough odd brass and stainless fittings laying around to throw something together. Cracked the valve open, shut the tank back off. Still holding pressure after a couple hours as you see. Pressure test complete.


[You must be registered and logged in to see this link.]

Sure is nice to have control of each line individually. Before I had 3 lines but they where all kind of tied in together. So to adjust one I had to adjust all 3 plus the needle valve to balance pressure out. That process could take an hour to dial in. With the splitter I had all 3 dialed in within a minute. Worth the $40 spent!!

[You must be registered and logged in to see this link.]

Where did you find this baby?

Ebay
There is a few different ones with different prices. This one was $40 with free shipping. Here is a link to one like it.
[You must be registered and logged in to see this link.]